Product description
The resistor boards on fuel modules are fragile so care should be taken during installation not to drop the module or put unnecessary pressure on the float arm or the resistor board unit. Boards can crack and not be easily visible to the naked eye.
Fuel level sensors are tested before they are packaged for shipment at our location and the impedance measurement recorded on the invoice. It is recommended they be tested by the installer just prior to installation to be certain no damage occurred during shipment or handling.
Using an OHM meter connect leads to the two center pins on the plug. There should be an approximate 180-200 Ohm spread from low to high.
Module comes as shown with no other accessories.Tank seal for installation is included.
MFM units do not have a pump inside.
For 98.5-04 Dodge Ram only, fuel gauge will not read properly if used on pre 1998 12v applications,
Be certain to read this page thoroughly before ordering as there are NO returns on fuel modules.
This unit does not have a pump inside.
MFM units do not have a pump inside.
For 98.5-04 Dodge Ram only, fuel gauge will not read properly if used on pre 1998 12v applications,
Be certain to read this page thoroughly before ordering as there are NO returns on fuel modules.
This unit does not have a pump inside.